Difference between ADS1115 and ADS1015

Question

Overview of ADS1115
The ADS1115 provides 16-bit precision at 860 samples/second over I2C for microcontrollers without an analog-to-digital converter or if you prefer a higher-precision ADC. Four single-ended input channels or two differential input channels can be installed on the chip. A configurable gain amplifier (up to x16) is included to help enhance smaller single/differential signals to the entire range. This ADC can measure a wide range of signals and runs on 2V to 5V power/logic. It's also very straightforward to use.

Overview of ADS1015
The ADS1015 analog-to-digital converters (ADCs) are precision, low-power, 12-bit, I2Ccompatible ADCs available in an ultra-small, leadless X2QFN-10 package and a VSSOP-10 packaging. The ADS1015 converts data at speeds of up to 3300 samples per second (SPS). The PGA allows precision large- and small-signal measurements with input ranges ranging from 256 mV to 6.144 V. The ADS1015 has two modes of operation: continuous conversion and single-shot conversion.

Conclusion of ADS1115 and ADS1015
The ADS1015 is a 12-bit ADC with 4 channels, and the ADS1115 is a higher precision 16-bit ADC with 4 channels. Both have a programmable gain from 2/3x to 16x so you can amplify small signals and read them with higher precision. These two boards are very similar, differing only in resolution and speed. The ADS1115 has a higher resolution and the ADS1015 has a higher sample rate.

If you want to learn more, try to follow the below link to see the article about ADS1115 and ADS1015.

If you are interested in these products, try to follow the below link to see ADS1115.

Answer 1

失せろ。