private networkとforwarded port を設定したいが、vagrant upできない

Question

###前提・実現したいこと
同僚からboxを渡されてVagrantfileを全くいじらない状態だとvagrant up後, vagrant ssh可能なのですが、vagrantfileに以下の設定を追記すると、エラーが出ます。

config.vm.network "private_network", ip: "192.168.33.10"
または
config.vm.network "forwarded_port", guest: 80, host: 8080

###発生している問題・エラーメッセージ
vagrant up後

==> default: Configuring and enabling network interfaces...
The following SSH command responded with a non-zero exit status.
Vagrant assumes that this means the command failed!

# Down the interface before munging the config file. This might
# fail if the interface is not actually set up yet so ignore
# errors.
/sbin/ifdown 'eth1'
# Move new config into place
mv -f '/tmp/vagrant-network-entry-eth1-1482227070-0' '/etc/sysconfig/network-scripts/ifcfg-eth1'
# attempt to force network manager to reload configurations
nmcli c reload || true

# Restart network (through NetworkManager if running)
if service NetworkManager status 2>&1 | grep -q running; then
  service NetworkManager restart
else
  service network restart
fi


Stdout from the command:

Shutting down interface eth0:  [  OK  ]
Shutting down loopback interface:  [  OK  ]
Bringing up loopback interface:  [  OK  ]
Bringing up interface eth0:  
Determining IP information for eth0... done.
[  OK  ]
Bringing up interface eth1:  Determining if ip address 192.168.33.20 is already in use for device eth1...
[  OK  ]
Bringing up interface eth2:  Device eth2 does not seem to be present, delaying initialization.
[FAILED]


Stderr from the command:

bash: line 10: nmcli: command not found

###補足情報(言語/FW/ツール等のバージョンなど)
virtualbox 5.0.14
vagrant 1.9.1

Answer 1

box等が不明なため詳細までテストできていませんが、vagrant 1.8.6 -> 1.9.1にしてから似たような現象が起きています。

config.vm.provision :shell, inline: "ifup enp0s8", run: "always"

を追記してはいかがですか？