petalinux上でのビルドについて
FPGA及びvitisを用いてアクセラレーションを試みています。
現在はpetalinux上でDevice Driver の追加や Kernel の設定変更を行い、ビルドをしているところです。
しかし、以下のようなエラーによりビルドが失敗してしまいます。
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
| make[2]: *** No rule to make target 'uImage'. Stop.
| make[1]: *** [Makefile:146: sub-make] Error 2
| ERROR: oe_runmake failed
| make: *** [Makefile:24: __sub-make] Error 2
| WARNING: exit code 1 from a shell command.
| ERROR: Function failed: do_compile (log file is located at /home/ishii/petalinux/2019.2/coraz7_2019.2/build/tmp/work/plnx_zynqmp-xilinx-linux/linux-xlnx/4.19-xilinx-v2019.2+git999-r0/temp/log.do_compile.12447)
ERROR: Task (/home/ishii/petalinux/2019.2/components/yocto/source/arm/layers/meta-xilinx/meta-xilinx-bsp/recipes-kernel/linux/linux-xlnx_2019.2.bb:do_compile) failed with exit code '1'
NOTE: Tasks Summary: Attempted 3534 tasks of which 1692 didn't need to be rerun and 1 failed.
Summary: 1 task failed:
/home/ishii/petalinux/2019.2/components/yocto/source/arm/layers/meta-xilinx/meta-xilinx-bsp/recipes-kernel/linux/linux-xlnx_2019.2.bb:do_compile
Summary: There was 1 WARNING message shown.
Summary: There were 178 ERROR messages shown, returning a non-zero exit code.
ERROR: Failed to build project
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
また、Device Driver の追加や Kernel の設定変更の際にも、successfully configured kernelとは表示されますが、それまでの過程でエラーが発生しています。
参考にしているサイトは
https://www.acri.c.titech.ac.jp/wordpress/archives/10058
こちらのサイトです。
基本的にvitisやpetalinuxなどはサイトと同じ2019.2のバージョンを用いています。
使用しているボードのみサイトと異なり、DIGILENT社のcoraz7を使用しています。
(今回はソフトウェア面でのエラーなのでボードは関係ないと思いますが)
知識不足でわからない部分も多いですが、回答する上で追加で必要な情報がございましたらおっしゃっていただけると幸いです。
ぜひとも回答よろしくお願いします。
あなたの回答
tips
プレビュー